Previously we got this part, to get ready to make silicone mold of the left side.
Flip it bottom up
we must take all our prototype out (foam, plaster, some of plasticine)
cut it carefully, do not cut reach silicone at bottom.
do not take plasticine plate out (it hold all dimension of fonts well)
remove some thick plaster out, if difficult no problem for this step just leave it.
it is enough for me. now be ready to make our work piece thickness.
to ensure that 2 side of mold will be locked each other. I will make the lock dimples.
5-6 dimples is much enough, make sure there is no undercut at all.
now make the thickness of our work piece by layering plasticine.
due to syringe already has 4 mm thickness then no need to make layer.
start 2nd layer, try to lay down completely then make it smooth.
this way makes you to ensure that you will have the right thickness. otherwise you will never know the desire thickness at all.
trim around
if you reach this step, you can ensure that you will be able to make silicone
of this side as well.
See... custom work is not too difficult at all now!
hope you enjoyed this present
thanks for watching
Bye for now ^^
No comments:
Post a Comment