Drill through with small drill bit.
use mounted point to expand as profile. (it's not circle)
This is the position at vertical
use small diamond point to grind as finishing.
Try to insert it into profile, gap is about 0.3-0.5mm is the best.
At bottom side, use mounted point to remove resin for switch position in vertical line.
reshape it until s/w can be fit in pocket.
this is challenge, to make it fit in pocket due to s/w must be sit as stable
while upper side has gap only 0.3-0.5 mm. you may spend lot of time on this.
finally, we've done.
To see detail, it's approximately 1.7-1.8 mm between "ON" and "OFF" position. Not finish yet, the lower part needs to be fillet.
remove edge around.
Once you remove material, you will lose texture. Then make texture now.
it's better.
Continue to reshape edge around and making texture together.
replace s/w module and check function if it works.
Overall looks ok.
As I plan not only 1 position for space man to stand, I'd like 2 more positions.
Then I made 2 more holes.
This hole is for space man turn around standing.
With this position, he will not be able to hold flag.
with this position, he will look stepping forward (I'd like this)
well this is all about part10 that is quite difficult for me, for you too???
Next part you will see the cloning of Satellite components.
Hope you are still enjoying.
Thanks for watching.
Bye for now... :)
No comments:
Post a Comment